Open the driver's side door of the Jeep Commander and then locate the Diagnostic Link Connector (DLC) below the dash.Renault CAN Clip This trapezoidal-shaped outlet may or may not have a protective plug covering it on the Commander. If a plug is present, pull it off by hand.
Plug the OBD II code reader into the DLC and then turn the ignition key to the key-on/engine-off position. This position is two forward clicks in the ignition that will power the Commander's electrical components without starting the engine. This will also provide portable power to the OBD II code reader.
Follow the instructions on the screen/menu of the code reader.VAG COM 17.1 There are many brands and types of code readers, but most employ a main menu with and up and down scroll button and an "Enter" or "Send" button.
Scroll to the "Read codes" option on the scanner and press the Enter button.
Write the code(s) down on a piece of paper for future reference. This is in the event the code(s) present on the Commander have been previously diagnosed and corrected by the repairs that caused the MIL to illuminate. In the event the MIL re-illuminates, refer to the paper and code as a reference.
Scroll back to the main menu on the OBD II code reader and select the"Erase codes" option.GM Tech2 The reader will most likely ask if you're sure you want to perform this step. Choose "Yes." A "Command sent" message will appear on the code reader, but do not remove the plug from the DLC until the main menu reappears.
Start the engine to the Jeep Commander and inspect the instrument panel to ensure the MIL is out.
College graduation regalia originated in the 12th century. That origin is the basis for all universities using the robes, pasteboard caps, and hoods.OBDSTAR Although each university has it's own rules for the graduation regalia, there are a few easy set rules to follow.
Wear the robe during the entire graduation ceremony. The most common color of robe is black. Shoes and dress pants should typically match the color of the robe.
Ensure that the cap with the mortarboard is level with the ground. The caps should be worn during the entire ceremony. Men might be required to remove the cap during prayer, national anthem or Alma Mater.gm tech2 Cues for removing caps at these times should be addressed beforehand but if they are not, watch the presiding officer and follow their lead.
Place the tassel on the right side before degrees are awarded. Once degrees are award, move the tassel to the left. Although this is common practice, this is not an official rule that is used by all universities and may not be done.
Put the graduate hood on over the robe. For some degrees, like a master's or doctoral, the graduate will be hooded as they are given the diploma. For degrees awarded en mass, the hood should be worn over the robes during the entire ceremony. Despite this rule,Yanhua Digimaster 3 many universities have removed the hood for bachelor's degree and the bachelor's robe will be worn without a hood.
Roll the edge of the hood outward so that the inside colors of the hood show. The end of the hood will look something like a fin and should not be turned inside out but hang parallel to the ground.